Glass Bed Clips and Holder by MaxWondercorn
Description
I Loved The Initial Design By Maxwondercorn (Https://Www.Thingiverse.Com/Thing:1320658) But I Read An Article About Auto Bed Leveling Where The Printer Will Go Over The 3 Mounts, Home The Z-Axis, And Lock The Bolt In Place. The Head Then Moves On And Repeats This Process At The Next Two Spots, Essentially Leveling The Bed. So With My Revamped Design Of Maxwondercorn'S, You Manually Tell The Printer Head Where To Go And Do The Above Steps. When You Go To Print, Drop The Bed Down Some Set Distance (I Drop It 0.25Mm). This Is Much Easier Than Doing The Paper Under The Head Method! Right Now I Use These Knobs Made By Funbart (Https://Www.Thingiverse.Com/Thing:641854) As My Method Of Tightening Down And Holding The Bed. I Did Include Thee Holes For M3*16 Screws To Hold The Bed But The Knobs Are Nice Because They Allow The Bed To Move In The Event Of A Collision.
Statistics
Likes
11
Downloads
0