ZMR led lowrider
Description
Zmr Led Lowrider Kit, For Carpark Racing You Need 3 Bottom Plates And 3Mm Arms, With M3 10Mm Standoffs/Spacers, M3 Locknuts And Various M3 Screws. There Is A Bumper For Front Or Back Under Deck 1, You Need To Drill Holes To Fit. There Is A 3Mm Spacer, For The Space At The Front And Back Under Deck 2, Same Level As The Arms. There Is A 3Mm Center Spacer For Under Deck 2, You Will Need To Trim It To Fit Around The 5V Bec If You Are Using The Pcb Inverted, For Deck 2, Like I Did. The 12Mm Part Is The Main Spacer For Under Deck 3. Use 10Mm Standoffs At The Front, Rear And In The Outside Arm Bolts, The Inside Arm Bolts Use Locknuts. Print It In Clear And Run A Strip Of Ws1812 Led'S Around The Inside, Make Sure To Cover The Back And Edges Of The Strip To Avoid Short Outs. Your Fc, Rx, Vtx And Led Bec Should All Fit In This Level. The Camera Mount Is For An Aomway Mini (15X15 Back, 17Dia Lens, Total Length 24Mm). 30Deg Uptilt. Its Pretty Chunky, But Is Tough Enough For Smacking The Concrete And The Lens Is Protected Because Its Set Back, With A 115 Deg Bevel. It Also Doubles As A Battery Stopper. Complete The Kit With The Blackout Motor Skids Designed By Pete Dee. Now You Should Have A Tough, Slippery, Well Lit Carpark Racer.
Statistics
Likes
52
Downloads
0