Trim Ring & Cap for P6*6 Pinhole Camera
Description
This Is A Bit Of Embellishment For The P6*6 3D Printed Pinhole Camera. Http://Www.Thingiverse.Com/Thing:157844 I Dislike The Flat, Unfinished Aspect Of The Front Face Of The Extension On The P6*6, So I Made A Face Plate For The "Shutter Clamp". Designed To Not Vignette The Image Projected Onto The Film, This Needs To Be Securely Glued In Place, As Popping The Cap Off Exerts A Small Leverage On The Trim Ring. At This Writing, I Have Used Super Glue To Good Effect. For Proper Fit, The Outside Perimeter Of The Trim Ring May Need To Be Slightly Sanded Or Smoothed With Acetone - Not Too Tight Or Too Loose! Additionally, The Cap Protects The Film From Accidental Exposure If The Shutter Should Get Knocked Open. Previously, I Have Been Using A Bit Of Gaffer'S Tape. ___ **Attention** This Work Is Licensed Under The [Creative Commons - Attribution - Non-Commercial License](Http://Creativecommons.Org/Licenses/By-Nc/3.0/). This License Applies Only To The Files And Documents Available For Download From The **Thing Files** Section Of This Thing. **All Other Related Content (Photographs, Videos, And Verbiage Such As Contained In "Description" Or "Instructions" ) Are Excluded From This License. With All Rights Reserved, Unless Specifically Available For Download** This Notice Constitutes A Clarification, Not A Change, To Licensing For This Design.
Statistics
Likes
33
Downloads
0