BQ Prusa i3 Hephestos Autolevel (no servo needed)

Description

<H3>What Is It Good For</H3> Its A New Autolevel Mechanism I Made For My Bq Prusa I3 Hephestos But It Should Fit On Other Printers Too. Unless Other Autolevel Solutions, No Probing Servo Is Needed. Also There Is No Probe Offset For X And Y And Very Little For Z And You Only Need To Print One Part, If You Reuse Some Parts Of Your Printer. <H3>How It Works</H3> In Normal Operation, The 2 Wires Of The Z Endstop Touch The Upper Linear Ball Bearing, Doing A Shortcut. If The Extruder Tip Is Hitting The Glass Base, The 2 Wires Of The Endstop Lose Electrical Contact To The Upper Ball Bearing And The Z Endstop Triggers. <H3>Disadvantages</H3> - The X-Axis Belt Minimally Gets Streched Everytime The Z Endstop Gets Triggered. - About Half Of The Extruder Weight (Depending On The Leverage Effect) Will Rest On The Glass Base, Everytime Before The Z Endstop Gets Triggered. <H3>What You Need</H3> - 3D Printer - Mechanical Endstop (Reuse Your Old Z-Endstop Or Make A New One. See Notes Below.) - 2X M3 Nut - 2X M3X25 Screw <H3>What You Need To Know</H3> How To Compile And Flash The 3D Printer Firmware!

Statistics

Category

Tags