Hole Saw Guide
Description
Guide To Hold A 90Mm (~3.5") Hole Saw In Place While Drilling Ceramic Tile. I Put Notches On The 4 Sides To Make Registration (Positioning) Easier. Made It Out Of Pla At .27 Mm And 10% Fill. I Used Thin 2 Sided Tape To Hold In Place And A Fair Amount Of Water From A Spray Bottle While Drilling (Cutting). I Put A Small Flange At The Bottom Of The Hole, Because My Printer Tends To Make The First Layer A Little Smaller. Not Sure Why???
Statistics
Likes
12
Downloads
0