WANHAO Duplicator i3 - Z Braces With Feet v1.0
Description
This Is My Personal Remix Of Two Things I Wanted To Add To My Wdi3. Putting Both Those Things At The Same Time On My Printer Would Have Been A Little Overloading. That'S Why I Decided To Combine Them. I Also Added My Little Touch By Adding A Ball Joint To The Lock-Nut Located Inside The Front Feet. This Way, The Braces Can Be Set In A Free State Before Squaring It. I Added A Support Arm On The Back Brace To Keep The Heated Bed Wires From Getting Tangled On The Y-Axis Bed, Specially When The Y-Axis Is At Its Ylarge Limit. I Got The Level Foot From My Local Hardware Store. I Think Mal3D Got His At Home Depot. These Are Cheap And Allow You To Level Your Printer On Uneven Surface. On My Setup, I Used Lock-Nut At All 8 Points, Just To Make Sure Vibration Wouldn'T Loosen Up Standard Nuts.
Statistics
Likes
23
Downloads
0