Robo3d R1+ build plate holder
Description
I Created These To Hold My Polycarbonate Build Plate On Top Of My Robo3D R1+ Glass Plate Without Limiting The Axis On Lower Z (Because Of Clips + Dual Fans). This Is Designed To Go Under The Glass Bed Over The Bump Of The Side Magnets. 2 Pieces Of The Same Type (2 Left / 2 Right) Should Be Enough, But I Included Both Left And Right In Case You Want Better Grip (Only The Right One Was Tested So Far). Edit: In The Pictures You Can See A Gap Between The Bed And The Holders, That Is Because My Plates Are A Bit Bigger Than The Bed And The Holders Bend To Add More Space --- Update: I Tried Printing All 4, But Noticed That There Is Something Interfering With The Top-Right One (Left Model Type). Also I Can Confirm It Works With Regular Pla And Prints Well With 2/3 Corners
Statistics
Likes
2
Downloads
0