Z axis wobble remover for GEEETech i3
Description
Bought A Geeetech I3! Great Value! Except It Came With A Bodgy Z Axis Drive. The Threaded Rods Were Bent. Leading To The Ripples/ Wobbles Associated With Such A Flaw. I Bought New Screws For It They Were Straight But Unfortunately Their Thread Was Too Coarse For The Steppers To Hold The Weight Of The X Axis. It Kept On Going Out Of True. I Looked Around For Another Answer To The Problem. There Are A Few Of These Guides On Thingiverse. Bernbout'S Thing Is The Basis For This One, It Allows The Bent Rods To Move More Freely Without Affecting The Z Axis Location. Mine Is A Little Thinner So You Don'T Need To Lift The Table Supports. Bernbout Did The "Hard Yards" And Should Be Congratulated For His Efforts. I Include This Part In Any I3 That I Make Or Rebuild Even If The Screws Do Not Seem To Be Bent.
Statistics
Likes
92
Downloads
0