Customizable Snap Hinge
Description
This Is A Snap Together Hinge That You Can Add To Your Projects. The Customizer Allows You To Adjust The Tolerances And Measurements To Fit Your Printer Accuracy And Project Needs. So Far I Have Tested This Out On The Kerrby Printer At The Bellingham Foundry Makerspace. I Suggest Printing Without Supports. The Code Needs To Be Cleaned Up A Little, But Future Updates Should Not Affect Functionality. The Hinges Shown In The Photo Were Made With The Following Settings: Large Hinge On The Left: $Fn = 70 Tabthickness = 2 Tabwidth = 6 Tabseperation = 3 Tabtolerance = 0.5 Pivottolerance = 2 Directdiameter = 5 Indentwidth N/A Diameterorwidth = 0 Use Ball Diameter Balltolerance = 0.3 Backlength = 5 Ballratio = .3 Small Hinge On The Right: $Fn = 70 Tabthickness = 1.75 Tabwidth = 4 Tabseperation = 2 Tabtolerance = 0.5 Pivottolerance = 2 Directdiameter N/A Indentwidth = 3.2 Diameterorwidth = 1 Use Indent Width Balltolerance = 0.25 Backlength = 3 Ballratio = .3
Statistics
Likes
61
Downloads
0