4x4.5 Propeller
Description
As I Now Fly Small Fpv Racing Quads I Decided That I Would Try And Print A Smaller Propeller For Them. I Hope You Enjoy The Result. So Far They Have Been Working Well On My Diatone Tyrant 180. If You Fine Tune Your Printer Then I Am Confident That These Props Will Come Off The Print Bed Without Needing To Be Balanced/Sanded/Reamed Etc. I Have Found That These Print Best With A Large Layer Height And A Slow Print Speed. I Would Recommend A Print Height Of 0.3Mm And A Speed Of 20-30Mm/S. 100% Infill Is Always Best But I Have Found Even A 20% Infill Works Well. Also If You Keep Your Nozzle Temperature And Bed Temperature High Then The Props Are Stronger I Have Found. I Have Been Printing Exclusively In Pla So Far With Great Results. I Have Yet To Try These In Abs Or Any Other Material But I Am Sure They Would Be Fine. If You'Re Like Me And You Break A Lot Of Props Then 3D Printing New Ones Is A Cheap And Quick Way To Get Your Quad Back In The Air. These Aren'T Meant To Be Better Than Moulded Props You Can Buy But They Are Meant To Be A Cheap And Quick Alternative. I Hope You Enjoy.
Statistics
Likes
139
Downloads
0