Griffin Frame connectors - modified Al extrusion cross-section
Description
Edited: I Changed The V-Slot Cross-Section So That My Poorly Calibrated Volcano Could Spit The Part Out. Sheepdog Has The Clearance Printable On A Typical Extruder Setup. My Problem Was With The Rounded Corners, The Plastic Would Round Them Out A Bit More And Then The Rails Wouldn'T Fit. Trying To Print A 90 Degree Corner Rounds It Out Almost As Much As The Original File. Might Work. Should Not Be An Issue If You'Re Printing On A Normal Sized Extruder/Nozzle. With These Stl Files, A 0.8Mm Nozzle, A 0.93Mm Extrusion Width With .64Mm Layer Heights... The Rails Slide Right In!
Statistics
Likes
4
Downloads
0