Stir Plate
Description
My Printer Was Hating The Source Design, Decided To Try My Hand At One Mine Can Handle. Https://Tinkercad.Com/Things/6U5Dween5Iu Https://Tinkercad.Com/Things/6Cjclkirhzi Https://Tinkercad.Com/Things/Ayzolqj91Je Fan: Http://Amzn.To/2Lh3Ome Pwm Controller: Http://Amzn.To/2Lh4Hvc Power Supply:Http://Amzn.To/2Lh3Zam Power Supply Jack: Http://Www.Ebay.Com/Itm/271757190320 Stir Bar: Http://Amzn.To/2Kgln2F Picked Up Some 0.5" Neodymium Magnets From Michael'S. I Glued Top Onto Base With Ca Gel. Then Ca Glued The Magnets Into Holder, And Holder Onto Fan. It Held With Just Magnet Force, But I Was Afraid It Would Throw Or Wobble Off Over Time So I Glued It Down. For Final Touch I Glued Some Rubber Pads Onto The Feet. I Also Ca Glued The Display Into The Base, The Tabs On The Sides Are Not The Most Robust Mounts Out There. It Could Be Prettier, But Black Pla Is What I Had Enough Of Left. The Hardware In Case The Hardware Links Go Dead: 5.5Mm X 2.5Mm Dc Power Supply Jack Guitar Pedal Panel Mounting 6V 12V 24V Digital Display Led Dc Motor Speed Controller Pwm Stepless Speed Control Switch Arctic F8 Pwm Rev. 2 Fluid Dynamic Bearing Case Fan, 80Mm Pwm Speed Control, 31Cfm At 22.5Dba 12V Ac Power Adapter For Maxtor Onetouch Ii Iii Hdd,3100 Personal Storage
Statistics
Likes
77
Downloads
0