Haenau - New parts
Description
These Are The Files For The New Back Mounts, Somewhat Lighter, And A Much Quicker Print. And More Aesthetically Pleasing :) Note: The 4 Screw Holes In The Bottom, Are A Little Close Together, So If You Are Any Good At Openscad, Then, I Would Recommend An Increase In Spacing, So It Is Easier To Fit Screws. And Moving The Drill Hole For The Pullies Out 1-2Mm, I 'Will' Eventually Get Around To It. And Post An Update ... More Parts Http://Www.Thingiverse.Com/Thing:1642930, And The Original Design .. Http://Www.Thingiverse.Com/Thing:1091057 As Well As A Few Others.
Statistics
Likes
7
Downloads
0