Bevel Gears
Description
I Needed Some Gears, Https://Youtu.Be/Rld1Zas6Yxa Shows Them Running. Seem To Fit Reasonably Well. Included The Openscad File With Settings From Gregfrost'S Thing. Printed At .2Mm Layer Height, 10% Infill (Final One I'Ll Do Thicker). One Axis Is Designed For A 30Mm Hex Shaft. The Other Is A 6Mm Shaft From Something Like A 37D Motor. The Motor Gear Has A 3Mm Set Screw Hole That Would Need Tapped To Use. There Are Two Different Sets: 13:43 And 15:37, I'M Not Sure What Gear Ratio I'Ll Need For Bb-8 :) The Shaft Of The Little Gear Printed A Tad Too Small, But I Expect You Guys To Adjust The Fittings To Fit Your Project. These Are Intended For My [Lego Bb-8](Http://Legobb8.Com) Flywheel Drive, We'Ll See How That Goes.
Statistics
Likes
95
Downloads
0