Funky Candle Holder [f3d-2]

Description

This **Funky Candle Holder**, Or Small Sculpture, Was Designed In Project Shapeshifter (Autodesk). Squares Are The Primary Geometry And Spinning Around The Z-Axis Is The Primary Motion. One End Is Closed To Form A Thin, Solid Base. This Is My 2Nd Full Design Using Shapeshifter But My [1St One [F3D-1]](Http://Www.Thingiverse.Com/Thing:227278) Came Out Better. I Rushed This One And Made Mistakes. Dimensions: **130Mm H**, **125Mm W (Top)**; **60Mm W (Bottom)**; And 30Mm W At Narrowest Point, Which Is ~20Mm Above The Build Plate. *Note: You Must Pay Special Attention To The Wall Thickness*. If You Print With Thin Walls And/Or Low Quality, A **Fatal Structural Weakness** Gets Exposed At The Thinnest Section. (2 Shells On Normal Was Too Weak For Me).

Statistics

Category

Tags