Versacopter GoPro Session and Boardcam mount
Description
This Mount Allows A Gopro Session And A 32Mm Board Camera To Be Mounted Side By Side On The Front Of A Flite Test Versacopter V2 (Never Test Fit On A V1). To Secure The Mount To The Top Plate, Four M3X8 Or M3X10 Screws And Nuts Are Required. A Narrow Velcro Strap Is Required To Restrain The Gopro From Above And A Small Layer Of Foam Between The Camera And Mount To Tension The Camera Against The Velcro Is Also Required. To Mount The Board Cam (28Mm Mounting Hole Spacing For A 32Mm Cam), You Will Need Four M2X6 Screws If Threading Into The Mount Or Longer Screws If Using Nuts. I Have Printed And Flown This Mount Without Issue. Using 6-Inch Props, A Small Amount Of Prop Is Visible In Frame In Each Cam As A Result Of The Cams Being Located So Close To The Edges Of The Top Plate. I Have Not Crash Tested It But Have No Reservations About It'S Strength. Pics Are Missing My Vtx And Antenna, As I Am Reworking The Vtx Mount. Antenna And Xt-60 Mount From Here: Http://Www.Thingiverse.Com/Thing:1664052 Skidplate From Here: Http://Www.Thingiverse.Com/Thing:1381484
Statistics
Likes
12
Downloads
0