Inductive sensor mount BQ Prusa i3
Description
This Modified Blower Will Be Handy For Those Who Have Added An Inductive Sensor To Their Bq Prusa I3. I Found Another One That Did Not Allow The Lower Nut To Be Inserted, I'Ve Corrected The Problem By Making The Place Where The Sensor Goes A Little Bit Narrower. I'D Recommend To Print This Part In Abs As It Lies Very Near The Hotend, Nevertheless I'Ve Used Pla And Everything Is Ok. I Bought My Sensor From Amazon : 3 Wire Noncontact Inductive Proximity Lj12A3-4-Z Connection: You Should Disconnect The Z Endstop And Instead Plug Your Sensor The Following Way: * Brown: Vcc (12V) * Blue: Gnd * Black: (Signal) With A Diode Like A 1N4148/1N4140, Plug The Cathode Of The Diode To The Black Wire And The Anode To The Processor Input. If You Plug It This Way You Won'T Need A Voltage Divider And Regulator Some People Suggest, It'S Easier And It Works Great. As For The Firmware, You Should Uncomment Enable_Auto_Bed_Leveling On Configuration.H And Change The Settings To Match Your Setup. I Hope You Enjoy It! Edit : Check Out My New Design Which Enables You To Have Led Lights On Top Of The Inductive Sensor! Https://Www.Thingiverse.Com/Thing:2348123
Statistics
Likes
62
Downloads
0