Cargo Area Anchor Point / Bungee Tie Down
Description
This Is An Anchor Point Intended For Use In Automotive Cargo Area Applications. The Tie Downs Are Designed To Be Installed On An Interior Panel Of A Car In The Cargo Area And Only Require That Two 3Mm Holes Be Drilled To Install It. The Two Part Design Functions As A Clamp That Sandwiches Both Sides Of An Interior Panel To Evenly Distribute The Load. This Design Is For Both Durability And Holding Power Without Deforming Or Warping The Interior Panel. In Addition To The Printed Part You Will Need 2 M3 Lock Nuts And 2 M3 Screws (The Length Of The Screw Will Vary Depending On The Thickness Of The Panel That You Want To Install It On.) I Designed These For The Parcel Shelf In The Rear Of My Mustang To Be Able To Bungee Tie Down Packages, Bags, Or The Occasional Pizza. Loads Shifting In A Car Can Be Very Dangerous And If You'Re Like Me And Enjoy Driving Spiritedly These Will Help Keep Everything In Place! These Would Also Be Suitable For Use In A Trunk, The Rear Of An Suv, Or Even The Cabin. Edit: At The Suggestion Of Reddit User "Exdot" I'Ve Included A High Load Variant With A Larger Edge To Edge Loop For Easier Printing And Additional Durability. Also, I'Ve Gotten Some Feedback That Not Everyone Has A Small Enough Hex Socket To Fit In The Back Plate So I'Ve Went Ahead And Made An Alternative Back Plate Design As Well.
Statistics
Likes
22
Downloads
0