Printrbot Simple XL Tower Filament Guide
Description
Here'S To All Of Us That Have The Printrbot Simple With The Xl Tower / Build Volume Tower Upgrade. Where The Filament Goes To The Left And Slips Off The Extruder Bearing... This Solves The Problem By Forcing The Filament To The Right. Also I Found That The Printrbot Bearings Were Too Far Offset For My Other Spools So I Created A Simple Rectangle To Hold The Two Bearing Holders From Small Spoolholder By Johnsl (Http://Www.Thingiverse.Com/Thing:93652) This Filament Guide Is Mounted Using The Same Allen Screws From The Simple Kit (You Should Have Some Extra) With Drilling A 5/64" Hole. The Dimensions Of The Mount Hole Are: 5.9Mm Countersink Diameter With 3.75Mm Countersink Depth. The Inner Hole Is 3.75Mm To Clear The Screw Threads. This Is Oversized A Bit To Accomidate Shrinkage From Your Printer. Good Luck!
Statistics
Likes
32
Downloads
0