Horus Kestrel Reinforced
Description
First And Foremost, This Design Is A Remix And Was Inspired By The Original Horus Kestrel. Http://Horus-Drones.Com/ Https://Grabcad.Com/Library/Horus-Kestrel-3D-1 I Had Printed, Built, And Flew The Original From Grabcad.Com And It Was Very Fun To Fly. However, I Noticed Some Play In The Rear Part Of The Air-Frame When Performing Yaw Movements. For A Printed Vtail Frame This Is Certainly To Be Expected. This Is My Attempt To Mitigate But Will Admit It Is Not Nearly As Good As A Rigid Cf Frame. The Only Parts That Differ From The Original Are: 1. Tail Plate 2. Main Body 3. Base Plate 4. Top Plate - Tail Plate Had Been Widened Near The Vblock Section And Has A M3 Tie In To The Main Body - Main Body Has Been Extended Near The Rear To Support The Tie In To The Tail Plate, And Includes M3 Tie-Ins To The Top Plate Near The Front And Rear Of The Airframe - Top Plate Rear Notch Has Been Removed - Adding In Support For The Tie In To The Main Body And Includes Additional Zip Tie Slots To Mount Equipment On The Top Or Bottom. - Base Plate Has The Word Horus Removed - My Printers Continued To Make A Mess For Some Reason Trying To Print This. Mobius Mount: Http://Www.Thingiverse.Com/Thing:1686351 My Current Setup Is As Follows @ 796 Grams Flip 32 Aio Dys 20A Esc'S Quanum (Dys) 2206 2000Kv Motors Frsky X8R Quanum Q58 Vtx Turnigy Ic-120Cs Ccd Camera Mobius Action Cam 2200Mah Lipo
Statistics
Likes
113
Downloads
0