Adafruit Light Sensor TSL2561 Housing
Description
This Is A Housing Component Designed To Hold The Adafruit Tsl2561 Light Sensor. It Is Intended For Use On Ftc Robots. It Is Recommended To Use 2-56 Screws To Secure The Circuit Board To The Housing. If You Printer Makes Holes Slightly Smaller, You Should Be Able To Put Threads Into The Mounting Holes. The Outer Mounting Holes Have 8Mm Spacing And Are Designed To Use 6-32 Screws. Again, The Holes Might Be Too Small, So You Can Frill Them Out With A #27 Drill Bit To Create A Through Hole (Or Create Threads). Update 7/30/16: Added A Model Designed To Hold Leds. We'Ve Used These 5Mm Leds From Vetco: Http://Www.Vetco.Net/Catalog/Product_Info.Php?Products_Id=15009 The Led Holes Should Be Bored Out With A 5Mm Drill, Then Glued Into Place. They Can Then Be Wired To A Digital Channel Port On The Device Interface Module. We Suggest Wiring Them In Parallel With A 100 Ohm Resistor Attached To Each To Compensate Different Amounts Of Light Emitting From Each Led.
Statistics
Likes
6
Downloads
0