Adafruit Multiplexer TCA9548A Housing
Description
This Is A Housing Component Designed To Hold The Adafruit Tca9548A Multiplexer. It Is Intended For Use On Ftc Robots. It Is Recommended To Use 2-56 Screws To Secure The Circuit Board To The Housing. If You Printer Makes Holes Slightly Smaller, You Should Be Able To Put Threads Into The Mounting Holes. The Outer Mounting Holes Have 8Mm Spacing And Are Designed To Use 6-32 Screws. Again, The Holes Might Be Too Small, So You Can Frill Them Out With A #27 Drill Bit To Create A Through Hole (Or Create Threads).
Statistics
Likes
4
Downloads
0