Vertical Mount Immersion RC's FatShark FPV 600mw Transmitter with OpenSCAD Source
Description
After Much Experimentation On Various Types Of Mounts For The Immersion Rc Fatshark 600Mw Transmitters, I Finally Developed One That I Liked Enough To Share. The Goals Were: 1) To Get The Clover Leaf Antenna As High Above Or Underneath The Airframe Of The Quad As Reasonably Possible. Antenna Mounts In Multiple Orientations, Up Or Down, Etc.. 2) Strong & Light, But Not Too Overly Engineered. 3) Tx Led Visible 4) Provide Plenty Of Cooling For Tx 5) Flexible For Varios Multirotor Or Quadcopter Airframes 6) Openscad 7) Somewhat Aerodynamic 8) Print With Out Supports (Well I Cheated Somewhat On This, You Can To Print Out The Slip In Tool To Assist) This Tx Mount Is Designed To Go Onto Aluminum 15.5Mm Homedepot Towel Rack Bar That I Use On My H Quad, Which Can Be Found Here: Http://Www.Thingiverse.Com/Thing:190912. If You Use A Fatshark Fpv Tvl 600 Ccd Camera, You Can Use My Http://Www.Thingiverse.Com/Thing:227037 To Mount To The Bar As Well. Note: There Are Still A Few Little Tweaks I Want To Make, So I Might Be Updating In The Future.
Statistics
Likes
71
Downloads
0