Snapple Aqua Globe V2 - Self Water Plant
Description
After A Few Modifications And Tweaks Due To Small Leak In Seal, I Managed To Get A Better Water Tight Seal (Not 100%). There Is A Slight Leak When The Bottle Is Tilted But There Does Not Seem To Be Any Water Loss Or Leak When Upright And Vertical As Intended. I Am Almost Certain That The Leak Is Being Cause By Support Material Being Used So A Completely Flush And Flat Seal With Top Lip Of Bottle Is Difficult To Achieve. You Might Have Better Print Settings Than Me To Compensate For This. - Added Outer Ring Bezel To Stop Walls From Bending When Tightening On Bottle. - Adjusted Size Of Thread Notches To Better Fit Snapple Bottle Design. - Made Cone Slightly Thinner As The Added Material Was Not Necessary For Structural Support. - Reduced Opening To Top Of Cone (From 4Mm Dia. To 2.5Mm Dia. To Restrict Water Flow Slightly For Longer Lasting/Less Frequent Refill. - Overall Length From 136Mm To 144.3Mm For Better Root Penetration. - Enjoy ;)
Statistics
Likes
224
Downloads
0