250 Quade Racer
Description
Tested 8/25: Flies Like A Scalding Ape!! Have Not Mounted The Fatshark Or Gopro Session To It Yet, But I Am Confident That It Will Still Perform And Have Plenty Of Power. Parts Used Below: Turnigy 3Cell 2200Mah Emax 15Amp Esc Arris 1806 2300Kv Brushless Motors Kk2 Flight Controller (Also Set Up To Run Dji Naza Light) Spectrum 6Ch Receiver 5045 Genfan Props Completed 8/18/16 : Finished Printing Complete. Adding Hardware And Electronics. . Added Landing Gear. Landing Gear Optional Or You Can Use Four Points When Installing The Upper Slab And Utilize 3" Bolts As Shown. Quade Arms: .2 Resolution ,75% Lateral Infill ,W/Supports, No Raft Lower Slab: .2 Resolution, 40% Infill, No Supports, No Raft Upper Slab: .2 Resolution, 40% Infill, No Supports, No Raft Landing Gear: .2 Resolution 100% Infill W/Raft And Supports Both Canopies: .2 Resolution, 10% Infill, W/Raft And Supports Update 8/15 Printed Well Had To Make Some Changes To The Motor Mounts. Updated Original Design. Updated: Just Finished Design And Have Not Printed. Will Update Once Kinks Are Worked Out If Any. Added: .Thing And .X3G Files
Statistics
Likes
3
Downloads
0