Engineering WORKBENCH - Drill Press , Table Saw , Tools
Description
I Have Seen An Assortment Of Tool Assemblies Across The Thgivrs And Internet. So I Decided To Put All Of The Tools Together Into One Large Workbench. This Is A Workbench Incorporating A Drillpress And A Circularsaw, And Multiple Expansion Arms For Additional Tools. The Workbench Sizes To About 18-Inches By 10-Inches By 12-Inches. * Drill-Press (On Leftside) * Circular-Saw / Router (On Rightside) * Work Table (In Center) All Tools Have: * Rear X-Adjustment Via Rear Main Horizontal Rods, * Z-Vertical Rear Rod Adjustment, * X/Y Positoning Arms. All The Tools Are Easily Removed And Re-Mounted On The Rear-Rods. All Wing-Screws Are Used To Allow The User / Engineer To Raise/Lower The Tools On The Rear Vertical Rods. There Are Wing-Screws That Allow The Arms To Loosen To Adjust X/Y-Distance. Also Adjustments For Tool-Tilt. This Can Be Done Starting From The Frame , Then Adding Modular Pieces: Rear-Vertical-Rods With Arm And Tool-Mount. The Bottom Frame As Pictured Here - Will Be Replaced (Is In The Current Process Of) By A Rod Supported Base. This Uses #6 1/2-Inch And 3/4-Inch Screws. Also, #6 3/4-Inch Wing-Bolts Are Used For User Adjusting. The Rods Are 1/4-Inch Steel-Rod From Home-Depot Or Lowes. Also See: 1744117 - Engineering Workbench - Table Saw This Is A Project In Continuous Improvement And Mods - Under Construction.
Statistics
Likes
289
Downloads
0