Flashforge Creator Pro 2016 Filament Holder Upgrade
Description
This Is An Add-On Upgrade To The Flashforge Creator Pro 2016 Model. I Recommend That This Is The First Thing That You Print When Unboxing Your Flashforge Creator Pro 2016 Because The Original Filament Feed Design Is Not Very Good. This Bracket Resolved The Issue That I Experienced Where The Filament Would Coil Off Of My Filament Roll And Would Get Stuck Between The Roll And The Printer Housing, Causing It To Stop Feeding Into The Extruder. Assembly Steps (Also See Attached Photos For Install): 1. Print Upright Without Raft/Supports Using Print Settings Described Below For Abs. 2. Click This Bracket Into The Same Holders As The Creator Pro Filament Guide Tubes On The Back Of The Case. 2. Insert The Filament Guide Tubes Into The Top Hole Of The Bracket. 3. Feed Your Filament Through The Small Hole In The Bottom Of The Bracket And Into The Filament Guide Tube And Load The Filament As Normal. P.S. If You'Re Annoyed That I Cut The Name "Bj Dizza" Into The Part And Don'T Know How To Remove It, Let Me Know And I Will Upload A New Version Without The Name (Or Another Name If You Want).
Statistics
Likes
26
Downloads
0