Overhung Blower for Haydn Huntley Magnetic Effector w/ modified Effector
Description
In An Attempt To Maximize Build Volume Of My Kossel Mini I Designed This Overhung Blower Filament Cooling System To Work With Haydn Huntley'S Magnetic Effector. Instead Of Hanging To The Side Of The Effector Head It Sits In The Unused Space Above The Effector Allowing The Hot End To Get Closer To The Towers Than If There Had Been A Blower Fan Mounted Outside Of The Effector Head. The Overhung Blower Adapter Uses The Empty Space Used To Insert The Hot End Into The Effector As A Pass Through For The Blower. It Is Designed To Bolt Up To The Accessory Mount On The Effector And Uses A Standard 50Mmx15Mm Blower Fan. The Compatible Effector Can Be Found Here: Http://Www.Thingiverse.Com/Thing:1546124 I'Ve Also Uploaded An Updated Effector Based On The Aforementioned Unit With An Additional Wiring Harness Pass Through To Allow The Hot End Wiring To Exit Up Through The Effector. The Cooling Tube Is The Correct Length For The E3D V6 Hot End. It Will Not Work With Clones At It'S Current Length. I Am In The Process Of Designing One To Fit Generic J Heads. This Part Is A Work In Progress But In My Tests So Far It Works Extremely Well. Since Installing It I'Ve Had No Filament Cooling Issues. I Will Likely Be Redesigning The Blower Attachment Straps To Provide Better Stability And Redesigning The Flanged Tube Mount And Solid Mount As A Single Piece. 2/15/2017 Update: I'Ve Now Printed Roughly 10 Pounds Of Plastics Through This Setup With Great Success. While I Will Continue To Update This Page As I Make Further Revisions I Would Deem This Setup To No Longer Be Experimental And To Instead Be Fully Functional And Usable.
Statistics
Likes
8
Downloads
0