Deer-Scarer
Description
Entirely Inspired By Http://Www.Thingiverse.Com/Thing:224441, But In Less Parts (3 Stls, Print The Peg Twice). Prints As Base And Arm And Peg, Sits Nicely Once Pegs Are Glued. Thing Sits Under Tap/Gentle Stream/Severed Limb, Fills Slowly With Liquid, Until Nearly Full, Then It Tips Forward, Empties Tapwater/Fresh-Foresty-Water/Blood, Then The Not-Hollow-Bit That Sits Below The Peg Once Again Is Heavier, The Arm Resets. Prints Well With Ultimaker 2, Sliced With Cura To Be "Hollow", Aka Criss-Crossed Lines, Otherwise The Lower Arm May Be Too Heavy For The Hollow Upper Arm To Outweigh Once Filled.
Statistics
Likes
19
Downloads
0