Typhon Hexagon Fan and Cooler
Description
This Is A Fan Mount For A 40Mm Fan For Use With The Hexagon Hot End Such As The One Included With The Makerfarm I3V. I Have Found A Few Similar Fan Mounts For E3D Hot Ends But Not For The Hexagon. I Based The Design On The 2-In-1 Fan Duct By Eipionezero But I Had To Start From Scratch On The Design As The Parts Are Of Different Sizes And The Length, Angle And Shape Were Slightly Different. There Are 2 Models: 1 Which Should Just Clip On But I Found The Fit Was Not Perfect And Depending On The Print Material, May Not Hold Up To The Heat Long Term. I Made A Version With A Small Hole That You Can Use A Small Zip Tie To Mount The Bracket To The Hot End. I Am Using A 40Mm X 20Mm Fan To Get A Lot Of Flow Through It. This Was Made With Autodesk Fusion 360, The Original Files May Be Shared If Requested For Further Modification. Thanks For Looking!
Statistics
Likes
33
Downloads
0