Makergear M2 Enclosure for Rambo board and Viki LCD
Description
This Was Designed As An All-In-One Enclosure For The Rambo Board And Viki Lcd On A Makergear M2. I Went For A Lower Profile Case So That It Could Be Wide Enough To Accommodate The Lcd While Still Allowing Full Travel Of The Z Axis. There Is Also A Slot On The Left Side Of The Cover To Allow For The Carriage Bolts When The Carriage Is All The Way Down. This Design Is Loosly Based On The Original Laser Printed Case For The M2, And The Viki Freestanding Case By Tysonl Http://Www.Thingiverse.Com/Thing:71343. A Howto Guide For Getting The Viki Lcd Working On An M2 Is On The Makergear Wiki Page Http://Makergear.Wikidot.Com/M2-Lcd-Panel. I Also Recommend Using The M2 Enclosure Latch By Tomlombardi Http://Www.Thingiverse.Com/Thing:57440 To Make Sure The Cover Is Secure, Although With My Print It Fits Pretty Snugly Without The Latch.
Statistics
Likes
73
Downloads
0