Anet A8 Electronics Case (Octopi, Relay + Mainboard)

Description

I Created This Electronics Enclosure For My Anet A8. I Have Setup Octoprint On A Raspberry Pi To Run The Prints And An Relay System (That Is Triggered Off The Raspberry Pi To Switch On And Off The Power And Also The Led Strip. I Also Included An Mount For A Pi Camera To Web Stream / Time-Lapse Your Prints. I Made The Decision Not To Include An Extra Cooling Fan On The Case As I Have Never Had A Problem With Over Heating And There Is So Much Passive Cooling From The Honeycomb Design. Having Said That It Would Not Be A Big Challenge To Add One In A Future Update. **You Will Need..**. Anet A8 (With Anet V1 Mainboard) Raspberry Pi 3 Pi Camera Network Connetion Or Wifi Module For The Pi Pi Power Supply (Make Sure Is Is An 2.5A Power Supply If You Are Using A Raspberry Pi 3) 30Cm Raspberry Pi Camera Board Replacement Cable (Http://Amzn.To/2Czomva) 2 Channel 5V Relay (Http://Ebay.Eu/2C6Nwk9) (Guide On How To Make It Work Http://Bit.Ly/2Czodc4) 18X M3X5Mm Self Thread Screws (Could Prob Use None Self Thread) (Http://Bit.Ly/2Crlvfa) 5X M3X 12Mm (Http://Bit.Ly/2Caytcm) 1X M3 Nut (For Camera Mount)

Statistics

Category

Tags