FT Kossel 2020 - 80mm RAMPS Cooling Fan Bracket
Description
This Bracket Holds An 80X25Mm Fan In Place Underneath A Folger Tech Kossel 2020 In Order To Cool The Controller Board (Ramps Etc). This Was Necessary For Me To Use The Heated Bed Without The Controller Throwing A Fuss (In My Case The Printer Was Throwing An "Extruder Mintemp" Error When The Bed Was Heating). It Mounts To The Acrylic That Supports The Heated Bed And Controller Boards. The Acrylic Slots Between The Edges Of The Bracket And Is Held In Place Via A Friction Fit, And The Fan Is Mounted Underneath The Printer At A 30Deg Angle From Vertical. Note That In Order To Add An 80Mm Fan (For Reference, I'M Using A Coolermaster Blade Master 80), The Printer Must Be Raised Somewhat To Allow Clearance. I'M Using Something Like These: Http://Www.Thingiverse.Com/Thing:1313461 Also, Make Sure You Cover All Ports Between Your Controller Board Support And The Heated Bed (That'S What All The Kapton Is For In My Photos)--Otherwise The Fan Will Cool The Heated Bed So That It Won'T Get To 100C (On 12Vdc Anyway). See Installed Photos For Example. Sorry I Don'T Have Any Very Visible As-Built Photos; Hopefully The As-Installed Photos Showing The Bracket And Fan Under Kapton Tape And Supplied Renderings Shed Light On Things.
Statistics
Likes
15
Downloads
0