Tevo Tarantula Z axis belt drive
Description
Z Axis Belt Drive For Tevo Tarantula! Say Goodbye To Z Wobble :) --- * * * Very Simple And Sturdy Design. Please Make Sure Your Frame Is Braced, The Tension Of The Belt Will Skew It Otherwise. **Careful: You Will Lose About 1Cm Of Print Volume On The Right Side Because The X-Carriage Will Crash Into The Belt Holder** --- Materials Needed: --- * * * -) 2* Gt2 Pulley 16 Tooth, 5Mm Hole, 10Mm Width -) 1M 10Mm Gt2 Belt -) 1* 40Mm M5 Bolt -) 1* M5 Nut -) 2* F695Zz Flanged Bearing (You Can Use Any Flanged Bearing With 5Mm Inner Hole But You Have To Adjust The Design!!) -) Small Zip Ties -) Mounting Materials: 10* M4 T-Nuts And M4 8Mm Screws **Please Note Instructions Below**
Statistics
Likes
28
Downloads
0