Hairspray Pump
Description
*Please Read The Safety Concern Section Below* Most Of You Have Glass Beds, And Hairspray Is One Of The Most Commonly Used Bed Adherence Tools. I'M Not A Fan Of Removing My Glass Bed Every Time I Re-Apply Hairspray So I Usually Fold A Paper Towel Into A Little Square, And Spray The Hairspray Onto There, And Then Wipe It On In A Thin Layer In The Middle Of The Bed. This Has Worked Great, Except I Need Two Hands To Do This, And I Always End Up Coating The Other Hand In Hairspray. I Was Modeled After A Can Of Unscented Extra Super Hold Aquanet, But This Has Fit With A Wide Range Of Compression Cans. *********Note********* *********If It Doesn'T Mist Out And It Ends Up Streaming Out, (The Hole May Seal Due To Over Extrusion), Just Take A Thin Needle Or Pin And Tap It Into The Hole. I Used A 0.5Mm Needle To Enlarge My Hole, Mists Perfectly Now********* 1) Print This Out 2) Pull Off The Spray Nozzle On Your Bottle Of Hairspray 3) Snap This Into Place 4) ... 5) You'Re Done! Now, I Have A Little Sheet Of Paper Towel Folded Next To The Can, And Every Time I Want To Apply Some Hairspray To The Bed Single Handedly, I Just Take The Paper Towel, And Press Down On The Mouth Quickly, And Wipe That On The Bed. Nice Single Even Coating Of Hairspray!
Statistics
Likes
443
Downloads
0