Prusa i3 MK2S filament runout sensor bracket/holder
Description
This Little Pice Of Plastic Will With An Optical Endstop And Octoprint Combined Save You From Failed Prints When You Run Out Of Filament :-) Remixed The Original To Be Able To Use A Ziptie For Fasteing. (As I Did Not Have Fitting Screws) Also Slimmed It Down A Bit To Use It With My Boden Holder And It Attaches Nicely To My I3 Mk2. - Octoprint: Http://Octoprint.Org/ - Filament Plugin:Https://Github.Com/Moonshinesg/Octoprint-Filament - Filament Sensor: Https://Www.Amazon.De/Optischer-Begrenzungsschalter-Endstop-Switch-Drucker/Dp/B00Ufw13Zo/Ref=Sr_1_1?Ie=Utf8&Qid=1474621615&Sr=8-1&Keywords=Optischer+Endstop - Pi Wireing: Https://Www.Raspberrypi.Org/Documentation/Usage/Gpio/ Example Wireing: G - Ground --> Ground On The Pi S - Signal --> Gpio 14 V - Volt --> 5 V On The Pi Test The Right Value For The Sensor: Http://Raspi.Tv/2013/Rpi-Gpio-Basics-6-Using-Inputs-And-Outputs-Together-With-Rpi-Gpio-Pull-Ups-And-Pull-Downs Write The Right Value Into Octoprint Config. Please Post Your Makes :-)
Statistics
Likes
196
Downloads
0