Filament cutter (only 9mm snap off blade needed)

Description

Yet Another Filament Cutter For 1.75Mm Filament.. The Filament Is Cut In An Angle By Sliding The Blade Forward. Goal: Fully Printable Small Filament Cutter. No Need For Springs, Screws, Washers, Nuts Or Anything Else That Requires The Correct Dimensions. The Only Hardware Is A Blade From A Standard Box Cutter (With Snap-Off Blade). The Snapped Part Should Be 9Mm.. I Managed To Design This From Scratch With Good Functionality. I Must Admit That It Was A Little Bigger Than What I Thought Was Necessary,, But It'S Printable And Light Weighted. A Short Video: Https://Youtu.Be/8Bqcjih7Eeq

Statistics

Category

Tags