OX Y Drag Chain Mount
Description
17Feb2017 -- Added Mounts For 40X15Mm Drag Chain Per Qbvbsite'S Request. I Havent Tested It Or Anything, But It Seemed To Fit His Well. "Remix" Of Ooznet'S Y Drag Chain Mount. Basic Dimensions Are All The Same, Except Re-Drawn From Scratch And Rounded Off. I Believe Theirs Goes The Other Way (You Mount The Chain On The Bottom), But Due To My Belt Tensioners And Stepper, I Didnt Have Room, So I Made This. Added Rear Mount. This One Goes Into The End Of The 'X' V-Slot In 3 Ways. It Has 'Nubs' That Go Into The Slot, Screws Also Go Into The End Of The V-Slot (Youll Need An M5 Tap), And Also Attaches With A T-Nut (Drop In Or Regular). Step File Included So You Can Modify It And Such. Made For A 15X30 Drag Chain, And The Hole Pattern Kind Of Matches That. Youll Need To Drill Out The Existing Holes (M4 Sized) To Allow An M5 Bolt Through, Or Stick With An M4, But You Will Need To Drill A New Hole, Just Forward Of The Other One, To Allow The Third Bolt Through, See Pic. Also Includes Inserts For M5 Nuts On The Bottom Of It, As Its Kind Of Hard To Get A Wrench In There With The Supports. Were All Those Supports Necessary? I Dont Know, But It Feels Pretty Hefty, So Why Not? If You Do Mount This On The Lower Holes (Right Above The Stepper Like I Did), Youll Need To Drill A New Hole In The Gantry Plate To Get It In (Mine Didnt Have It At Least).
Statistics
Likes
46
Downloads
0