Fan with Wire Management - Max Micron and other Prusa i3
Description
Just Added Wire Management To My Improved Parts Cooling Fan Shroud. *Version Without Wire Management If You Prefer... * Http://Www.Thingiverse.Com/Thing:1794658 • Improved Cooling Over Stock Unit As The Fan Duct Is Brought In Closer To The Needed Area But Much Less General Air Blowing Around The Nozzle And Heat Block. • Better View Of The Nozzle With The Duct Tucked Up Closer To The Carriage. • Small Shield In Mouth Of Duct To Lower Direct Air Flow At The Nozzle Tip. • Better Access Incase Of Failure Or Other Issues Than Many Of The Modified Shrouds That Wrap Around And Block The Nozzle • Added Simple Wire Management Coming Off The Head To Avoid Droop And Lower Wire Stress During Movement. **Note- Check Your Layers In The Slicer, Rotate The Model On The Bed To Get The Support Material To Run Front To Back Over Side To Side As It'S A Lot Easier To Remove From Inside That Way. **
Statistics
Likes
21
Downloads
0