Industrial pipe components for Warhammer40k
Description
Component List: -90° Elbow Left Hand Turn -90° Elbow Right Hand Turn -90° Elbow Down/Up Turn -Little Top T-Section Cap I Have Made 3 Different Elbows, And A Top Cap Component That Can Be Added To A Length Of Plastic Piping. The Specific Pipe I Used Is Shown In The Link Below, But You Can Try Other Pipes As Well As Long As The Outer Diameter Is 42.27Mm Or 1-11/16Th". I Have Included A Link Below That Shows The Type Of Pipe You Should Use For The Straight Section: Http://Tinyurl.Com/Htmvo4S I Used A "Form2" Printer, @ 0.025Mm Print Resolution To Make The Parts Shown In The Image Above, So You May Need To Do A Bit Of Sanding And Finishing If You Plan On Printing With Any Printer That Works At A Lower Resolution.
Statistics
Likes
289
Downloads
0