Twitch Cube Joystick
Description
A Joystick For The Twitch Block Http://Www.Thingiverse.Com/Thing:1798009 Takes The Place Of The Ball Bearing At The End. The Gasket Needs To Be Printed In Some Sort Of Flex Filament. You Can Put A Magnet In The End Of It And One In The Block If You Want It To Attract To The Middle Or How I Like It Oppose Each Other And Act Against You Trying To Center It. I Am Also Including A Version Of The Block That Prints In Two Parts - The Whole Stopping Mid Print Thing Was Getting Old When Printing Many Of These. Additionally Is A Version Of The Block Which Uses 4X2Mm Magnets To Hold On The Plates, Allows Me To Design New Plates And Swap Them In And Out Easily.
Statistics
Likes
53
Downloads
0