Trucks for Z-18 Penny Skateboard
Description
If A 3D Printed Board Is Strong Enough For A Person To Stand On, Why Not Print The Trucks And Wheels As Well? So That'S What We Did. We Used The Beautiful Pennyboard Designed By Andrew Askedall, Http://Andrewaskedall.Com/, As The Base And Designed These Truck Based On Pictures Found On The Internet. Not A Single Person In Our Colorfabb Organization Knows Anything About Skateboarding Or Designing Skateboard Parts, But We Think It Turned Out Well Enough To Share With You. <A Href="Https://Www.Youtube.Com/Watch?V=Jsqauf0I6Vq"></A> The Board Was Printed On A Delta Tower With Colorfabb_Xt, Board Was Placed At A Slight Angle Instead Of Straight Up To Increase The Layer Cross Section. We Used A 0.8Mm Nozzle. The Trucks Have Been Printed In Colorfabb_Ht, On The Mass Portal At 80% Infill And 3 Perimeters, Using A 0.6Mm Nozzle. All The Ngen-Flex Parts Have Been Printed On The Mass Portal, Using A Buildtak Sheet.
Statistics
Likes
117
Downloads
0