Endoscope camera holder "angled" for Original Prusa i3 MK2

Description

I´Ve Remixed (Redesigned From Scratch Based On The Remix Source Measurements And Idea) This Cause The Original Design Showed Too Much Of The Fan Duct And Had The Nozzle Not Centered (Check Https://Www.Youtube.Com/Watch?V=E4Wvldq7F-W For The View - Yes I Know The Camera Wasn´T Setup Up Correct). So I Redesigned This With Another Angle And A Slightly Closer Tube To Fit My Camera Better. See Picture Above For The New View - The Angle Was Necessary Cause Otherwise The Cable From The Camera Would Be Squished In Between The Left Z Carriage And The Holder While Homing Or Print On The Far Left Of The Bed. Can Anyone Recommend A Endoscope Camera With A Stable Frame Rate And Full Hd Resolution (Or Is This Impossible In This Small Form Factor ?) Update: Since My Camera Was Not Properly Fixed - I Reduced The Diameter By 0,1 Mm. There Are Two Versions Now 69 Means The Diameter For The Camera Is 6,9Mm And 70 Means Its 7,0Mm - If Your Camera Is 7,0Mm I´D Recommend The 69 Version - It Will Hold The Camera Better Than The Other One. Update: The Camera Kept Falling Out And Securing With A Zip Tie Isn´T Technically Correct ;-) This Led To V2 Version With Integrated Locking Brackets For M3 Screw And Nut (I Didn´T Try Printing An M3 Thread - But Maybe It Could Be Cut). See Photos And Stl Attached - Video Of The Making (Https://Youtu.Be/Hnqc29Brr1C) And The New Angle (Soon To Come) Update: Check Out The V4 Version - After Some Hours Of Recording The Camera Came Loose Again So I Decided To Make A Screw To Fix It. Similar To The First Screw Version This Has Two Brackets But This Time One Of The Holes Is Bigger And The Other One Smaller - So If You Use A Tapping M3 Screw This Should Work As Mine. Old Files Are Still Here In Case You Want To Tinker Around With. V5 Update: I Needed My Camera A Bit Further Away From The Nozzle To Have A Better Focus (Check The Blurry Videos). V5 Provides This - See The 2 Pictures Of The New View.

Statistics

Category

Tags