M6 Funnel Bolt - MK8 Extruder Filament Guide
Description
>**Edit:** Just Noticed The Scaling May Have Been Off On Either One Or Both Of The 4 And 7 Mm Bolt Stl Files. If You Downloaded The V02 Stls, Please Get The V03 Models Instead. I Also Added An Stl With Both The 4 And 7 Mm Bolts For Those Wanting To Print Both At Once (For Whatever Reasons). An M6 Bolt With A Funnel Shaped Hole In It. I Made It As A Sort Of Filament Tip Guide For Anycubic'S Metal Mk8 Extruder Kit (See Photo). It Makes Threading Filament Into My Printer'S Bowden Tube Much Less Of A Struggle. Note The Photo Is Of The "Right Hand" Version Of The Kit. If You Are Still Using The Stock Extruder, Try My [M6 Nut Funnel Cover - Exruder Filament Guide](Http://Www.Thingiverse.Com/Thing:1874865). **Notes** There Are 2 Versions, One With 4Mm Of Thread And One With 7Mm Of Thread. Installing The 7Mm Version Will Require Removing The Extruder Base Plate From The Top Of The Printer (If Installed). I Made The 4Mm Version Because I Had Already Installed The Base Plate And Didn'T Want To Remove It To Install The Guide Bolt. Installing The 4Mm Bolt Without Removing The Plate Is A Little Tricky, But It Can Be Done. This Was Designed This For Use With 1.75Mm Filaments, It Will Not Work With 2.5 Or 3 Mm Filaments (The Hole Diameter Is Close To 2.55Mm). Should Be Printable Without Supports, I Recommend Using A Small Layer Height To Preserve The Threads (I Used 0.1Mm).
Statistics
Likes
63
Downloads
0