FlashForge Creator Pro 2016 Lid Shield
Description
This Is A Remix Of Seamongrel'S Flashforge Creator Pro 2016 Lid Holder. I Modified It To Use One 3/4" Ceramic Disc Magnet. (I Used An "Ook" Brand Magnet From Walmart That Is ~18Mm In Diameter By 5Mm Thick). Like The Original, It Will Keep The Lid From Chattering. I Also Extended The Portion Inside The Lid So That It Could Help Keep Heat In The Enclosure. I Recommend Printing With The Longer Flat Side Down. Print With Supports. Once You Do Any Necessary Clean Up, Glue In The Magnet. The Part Easily Slips In The Gap At The Back Of The Lid And Fits Over The Screw Heads.
Statistics
Likes
20
Downloads
0