Raspberry Pi Camera Mount for FT-5 or any 2020 extrusion
Description
In Conjunction With Http://Www.Thingiverse.Com/Thing:1867512 , The Cradle For A Raspberry Pi 3 Set Up, I Needed A Mount For The Raspi Camera That Would Fit The Top 2020 Extrusion On The Folger Tech Ft-5. This Mounts And Snaps In Place To Hold The Camera At A Good Angle To See The Build Surface. It Holds This Camera Case > Http://Www.Thingiverse.Com/Thing:472028. Although It Says It For The Noir Version, It Really Makes No Difference What Camera Goes Inside. Since I Had The Volcano Hot End In Place With A 0.8 Mm Nozzle, That'S What I Used With Esun Pla+. It Is Very Strong And Flexible Enough To Snap In Place. Ps: I Had To Tilt The Holder Back 5 Degrees To Get A Better View Of The Nozzle. That'S Reflected In The Files Now. Pps: I Added Another 5 Degrees To Maximize The View From The Middle Rail, Rather Than The Top Rail. It Is The 'Revised' Version.
Statistics
Likes
11
Downloads
0