Tevo Tarantula i3, Sides and Legs for Acrylic Display Case
Description
This Is A Side Panel Cover And Legs For The Acrylic Display On The Tevo Tarantula And Other Similar I3 Printers. The Long Sides Are Split In Two Pieces As My Tevo Was Being Rebuilt When I Designed This. So These Were Made On My Monoprice Mini Select. They Are Designed To Slip Over The Brass Standoffs, And Will Use All Factory Hardware With The Exception Of : 2 M3X16 Cap Screws And 2 M3 Nuts For The Split Long Sides . : 4 M3X20 Cap Screws Washers And Nuts For Bolting The Legs To The Back Case. As A Precaution, I Placed A Strip Of Electrical Tape Over The Portion Of Pcb Board For The Lcd. This Is To Prevent The M3 Screw In The Split Joint From Scratching Any Traces. You Will See What I Mean, And See How I Recessed The Area Of The Sides For This. This Is Still A Work In Progress. If Anyone Would Like To Contribute A 1 Piece Design Of The Long Side, It Would Be More Than Welcome And I Could Provide The Files If Needed To Do So. I Am Ok With Where This Turned Out For Me, So I Don'T Plan On Putting Anymore Time Into It As Of Now....
Statistics
Likes
23
Downloads
0