Y-axis Endstop for Prusa i3 Rework
Description
This Is A Rework Of A Y-Axis Endstop. It Looks Like The One I Had Was Based Off This Endstop (Http://Www.Thingiverse.Com/Thing:82631). I Needed A Spacing Of 30 Mm For My Printer So I Redrew The Part In Fusion 360. I Left The Slot As A Through Hole To Allow Placement On The Left Or Right Side Of The Printer. <B>Note:</B> Part Will Most Likely Need To Be Rotated 90 Deg. About X Axis Is Your Printing Software. For Some Reason Projects Designed In Fusion 360 On The Top Plane Are 90 Degs Out When I Load Them Into The Printing Software.
Statistics
Likes
11
Downloads
0