FT5 Z Stop FolgerTech Titan V6
Description
This Is A Modification From The Original By Morskipas. I Extended It To Allow For The Longer Body Of The E3D Titan V6 Mounted On The 713Maker.Com Bracket. I Will Be Modifying This As Needed. Assembly Is Easy. 1. Print With Orientation As Shown In The Image. 2. Disconnect From Power 3. Remove Z Stop From The Thin Supplied Bracket 4. Install It On The Newly Printed Bracket (There Is Space For Back Of Board Solder Tails) 5. Install T Nuts And Hex Bolts 6. Install On 20 20 Rail 7. Get Long Bolt And A Nut Left Over From The Build (Should Have A Few Left Over). 8. Get A Small Washer And A Pen Spring (Rip Apart An Old Pen, Not Your Wife'S Favorite) 9. Get A Square Nut For The Top. 10. Put It All Together As Shown In The Photo. That Is It, Just Get It Rough With An Auto- Home And Then Do Fine Adjustments By Moving The Screw Up Or Down As Needed
Statistics
Likes
13
Downloads
0