X carriage all in one for e3d v6 and bulldog ,for long Alu/Printed blocks.
Description
I Changed My 2 X Axis Bearings For 2 In 1 Alu Block. Also Added The Printable Version Instead Of Alu Block ( The Printable Block Is Not My Design ) This Carriage Is Made To Use These Blocks With A Bulldog Extruder E3D V6 And A Inductive Sensor. The Alignment Of The X Axis Is Perfect With This, You Can Place The Blocks On Your Smooth Rods And Then Tighten The Carriage To Them So You Have No Binding. I Had To Raise The Motor To Be Able To Get The Inductive Sensor Under It, To Achieve This I Have Made An Adapter For Between The E3D V6 And The Bulldog Extruder, The Adapter Works Best With A Teflon Tube In It. You Need 2 Regular Clamps For The Bowden Version, And 1 Regular And 1 Low Clamp For The Direct Version, I Changed The Heights Of The Belt Holders, Because In The Mendelmax 1.5 A Large Bearing Is Used Which Makes The Belt Go Lower On That Side. This Is Made To Make The Belt Go Paralell As It Travels. I Have Also Made A Bowden Variant. If You Want A Change For Your Specific Printer Feel Free To Drop A Comment. I Also Would Appreciate" I Made This" Photos. Cheers
Statistics
Likes
6
Downloads
0